Contact us Toll Free at: 877-535-9033

LineClear Irrigation Treatment

Product Description:
     LineClear 50 is a unique blend of specialized phosphonic acids and mineral sequestering ingredients manufactured to provide an overall water treatment mineral stabilization formulation for agricultural irrigation systems.  The effective dosage rate for LineClear 50 is typically in the stoichiometric range of 1:100,000 meaning one gallon of LineClear 50 can generally treat 100,000 gallons of irrigation water.  With this treatment ratio, LineClear 50 is a very cost effective remedy to many irrigation water quality problems.

     LineClear50 will inactivate or sequester minerals including iron, calcium, and manganese naturally found in irrigation water preventing mineral scale deposits from forming which could clog microjets, sprinkler heads, drip lines, and pipe lines.  This assures that valuable irrigation water will be available to the plants systemwide.  LineClear50 also has ingredients that will inhibit potential internal corrosion from occuring on the interior surfaces of the system and sprinkler heads/jets.  It is an effective overall treatment for controlling minerals and scale along with corrosion control for agricultural irrigation systems.

 
      Composition: ......................................................................................................................................................... Liquid
      Appearance: ................................................................................................................. Clean, Clear to pale yellow tint
      Bulk Density: ................................................................................................................................................ 9.47 lbs/gal
      pH of 1% solution:  .................................................................................................................................................. <2.0
       % Active Acid:  ............................................................................................................................................................ 25
      Specific Gravity: ....................................................................................................................................................... 1.14
 

Application and Dosage:
     LineClear 50 is applied to the water system by use of a chemical injector pump or peristaltic pump.  Typical treatment dosage range from 1.50 mg/L - 6.0 mg/L but is generally fed at 2.5 mg/L.  Approximately 1 gallon of LineClear 50 will treat 100,000 gallons of water at a 2.5 mg/L dosage.  LineClear 50 is an extremely stable sequestering agent over a wide range of temperatures and pH.  Please refer to the LineClear 50 MSDS for handling information.

Packaging:
     LineClear 50 is available in 5 gal. pails and, 30 and 55 gallon drums, F.O.B. Clearwater, Florida 33760.

                                                                                                     NOTICE
The information herein is to our knowledge true and accurate.  All information appearing on this document is based on data obtained from the manufacturer and/or recognized technical sources.  Because of conditions beyond our control, we make no warranty or representation, expressed or implied, except that the product discussed herein conform to the chemical descriptions shown on their labels/product data.   Information is supplied upon the condition that the persons receiving same will make their own determination as to its suitability for their purposes prior to use.  In no event will SPER Chemical Corporation be responsible for damages of any nature whatsoever resulting from the use of or reliance upon information or the product to which the information refers.  No agent, representative or employee of this company is authorized to vary any of the terms of this notice.

Copyright © 2000-2010 SPER Chemical Corporation